📝 Full-Length Practice Exam

Certified SOLIDWORKS Associate (CSWA)

Administered by Dassault Systèmes (SOLIDWORKS), via the 3DEXPERIENCE / MySolidWorks certification program

31
Questions
90 min
Time limit
70%
Pass mark
Open-reference
References
What this is

A study-practice exam covering the domains of the Certified SOLIDWORKS Associate (CSWA) exam: sketching fundamentals, basic part modeling (extrude and revolve), advanced part modeling (sweep, loft and patterns), assembly mates and configurations, drawing view creation, and the basic concepts behind SOLIDWORKS Simulation.

References you may use
  • SOLIDWORKS CSWA Exam Guide (Dassault Systèmes)
  • SOLIDWORKS Help documentation and MySolidWorks training
Topics covered
Sketching FundamentalsBasic Part ModelingAdvanced Part ModelingAssembly Mates & ConfigurationsDrawing Views & AnnotationsBasic Simulation & FEA Concepts
⚠️ The real CSWA exam is a proctored, hands-on test taken inside SOLIDWORKS itself, where candidates build parts and assemblies and enter numeric or multiple-choice answers based on the resulting model (mass, volume, center of mass, and similar measurements) — it is not a plain multiple-choice quiz. These are original knowledge-check questions written for self-study on the published CSWA exam objectives; they are not reproductions of the official exam and are not affiliated with or endorsed by Dassault Systèmes / SOLIDWORKS. Always verify current exam objectives at solidworks.com/certifications.

The timer starts when you begin. You can flag questions and revisit them before submitting.