3D EXPLORERS & INSPECTORS · INCLUDED WITH ALL-ACCESS
Water Treatment Virtual Facility Inspector
Fly through six connected process areas, inspect 25 equipment groups, follow coordinated system diagrams and solve three evidence-based inspection missions.
Change one input, predict the response, then inspect the result. Each activity states its model and assumptions. Saved activities and comparisons stay in this browser.
A connected plant, from raw water to distribution
Explore a fictional conventional surface-water treatment facility in the Environmental & Water Resources Studio. Follow a six-stop guided tour, navigate freely in orbit or drone mode, or investigate three fault scenarios. The plant includes treatment basins, chemical-feed assemblies, parallel filters, storage, duty/standby pumps, electrical equipment and field instruments.
What you can inspect and learn
1 · Raw-water intake
Screens intercept large debris. Raw-water pumps lift water to the treatment train. This fictional plant treats surface water; it is not a wastewater plant.
2 · Coagulation & flocculation
Rapid mixing disperses coagulant. Slower paddle mixing encourages particles to form flocs. Dose depends on source-water conditions and testing, not a universal setting.
3 · Sedimentation
Gravity separates settleable floc. A scraper collects sludge, while clarified water passes over an outlet weir. Sludge goes to residuals handling.
4 · Granular filtration
Two parallel media cells remove remaining particles. Differential head indicates resistance. Backwash removes accumulated solids; one cell can remain in service.
5 · Disinfection contact
Disinfectant is introduced before a baffled contact basin. Effective contact depends on hydraulics and water chemistry. This model does not calculate pathogen inactivation or regulatory CT compliance.
6 · Clearwell & distribution
The clearwell buffers treated-water demand. Duty/standby pumps deliver water to a conceptual distribution header; level, flow and pressure instruments support control.
Compare the 3D equipment with its coordinated process diagram. Inspect flow, level, local and header pressure, filter differential head and a fictional residual signal. Record observations before diagnosing a blocked discharge, an unusually resistant filter or disabled disinfectant feed. Virtual restoration lets you compare the before-and-after signals.
This is an educational model with illustrative signals, not a surveyed plant, real drone inspection, operational procedure or drinking-water compliance assessment. Full interactive access is included with All-Access; this introduction is public.
How to use this learning workspace
Start with the default worked example. Identify the inputs and units, change one variable at a time, and compare the diagram and numerical readings. Use the component inspector in 3D views, the measurements in diagnostic activities, and saved runs in the analytical workbenches. These are educational models with explicit limits, not validated project designs.